Gp14 rigging manual pdf

well as information from the Department of Energy's (DOE's) Hoisting and Rigging Manual and ANSI B30. 9. Definitions Asymmetrical load. An object with an offcenter center of gravity due to the object's irregular shape andor composition.

Jul 30, 2012  Well, I finally made time to get my" new" 1958 GP14 out on the dirve& check it over. The Hull seems to be in good order& the sails are not 55 years old but it has had lots of alterations to the running rigging& not all The content of the PNNL Hoisting and Rigging Manual was derived from the Hanford Site Hoisting and Rigging Manual (DOERL9236).

Permission was given to the Hanford Site Hoisting and Rigging Committee to use and reproduce portions of standards and information from the following sources: BEGINNERS GUIDE TO RIGGING THE GP14 Introduction Because the GP 14 is not a true onedesign boat, it has many variations in the way it can be rigged, although this has become more standardised in recent boats.

This guide is designed not only as a beginners guide for those new to the Class but GP14 TUNING GUIDE The aim of this tuning guide is to help you get the most out of your GP14. Although the following measurements should enable you to set your boat up close to its ideal settings, it is worth bearing in RIGGER REFERENCE MANUAL RGR RM 0314 NATIONAL COMMISSION FOR THE CERTIFICATION OF CRANE OPERATORS (NCCCO) IPTs Crane and Rigging Training Manual Rigging for Ironworkers Reference Manual NCCCO Rigger Reference Booklet The Gp14 rigging manual pdf contained herein is not to be used for any other The material outlined in this manual outlines the requirements of the DOE Hoisting and Rigging program.

It requires persons who perform rigging or operate hoisting equipment to be trained to ensure that the personnel are competent to perform the Hoisting& Rigging Fundamentals This manual identifies the basic hazards in rigging and hoisting, explains the safeguards necessary to control or eliminate these hazards, and spells out other essential safety requirements. The information should be used in conjunction with the applicable regulations by contractors, Page 1 GP14 CLASS INTERNATIONAL ASSOCIATION MEASUREMENT FORM Notes and Instructions Before a boat is presented for measurement, the Owner should check that the Builder has signed Topper Rigging Manual P 14 Specifications and instructions contained herein are subject to change without notification.

The rig a combination of masts, booms, rigging and all types of equipment. GOACHER SAILS GP 14 TUNING GUIDE Goacher Sails GP settings Measured on 2008 Dufn thro deck sheeting Selden mast Transom to front gate 2888 mm Transom to aft face of mast at heel 2830 mm Transom to shroud 2405 mm Shroud to shroud 1329 mm Jib tack pin to shroud 1959 mm Jib tack to back of tracks 2390 mm This manual is intended as a working guide for training workers and supervisors in the fundamentals of safe rigging and hoisting.

The information covers Gp14 rigging manual pdf only ropes and knots but hoisting equipment from cranes to chainfalls



Phone: (330) 845-5497 x 3031

Email: [email protected]